 |
 |
 |
 |
 |
 |
 |
Features
- Four layer PCB with Nickel Immersion Gold plating and red solder mask.
- 400 - MHz Arm Processor (500 Mips !).
- 256 - megs of Nand Flash. Create and store custom applications.
- 64 - megs of SD-Ram.
- Hyper efficient Low Noise Switching Power Supply, accepts 8 - 60 vdc input. Can be powered directly from 12, 24, or 48 volt battery banks.
- Battery backed-up, real time clock.
- One onboard temperature sensor - 25c + 100c.
- Eight 24 bit isolated voltmeters (+/- 100 VDC). Each voltmeter has its own 24 bit Delta Sigma ADC.
- Four Latching Power Relays for devices using up to 240v - 15 amps AC/DC current.
- Three programmable push buttons.
- Six general purpose I/O pins.
- Five alarm input pins.
- Power output port, 5.0vdc (500ma).
- Power output port, 3.3vdc (500ma).
- One full serial port for controlling cell phones, modems, GPRS, etc.
- One console serial port for full terminal access.
- Two USB 2.0 ports for cameras, wireless clients, extra Ethernet, etc.
- Runs real Linux! 2.6.33 kernel.
- Send SMS messages, Email alerts, SNMP traps, Remote Syslog Messages.
- Ping watchdog, power cycle equipment after a set amount of ping timeouts.
- Command line utilities: ping, ftp, email, relays, etc.
- Flash new firmware over the internet.
- Duel Watchdog Reset circuits, processor integrated, and extra hardware.
- Control RMS-300 via web page, telnet, ssh, or snmp.
- Full SNMP v1, v2, v3 support (default v3).
- Supports external USB relays, voltmeters, and temperature sensors.
- Hardware is user accessible from files on the board.
- Make your own utilities and scripts to upload. (Bash, PHP, Perl, Python, Lua, TCL)
- Pluggable connectors for ease of use.
|
|
 |
 |
 |
 |
|
 |


|