 |
 |
 |
 |
 |
 |
 |
Features
Six layer PCB with Nickel Immersion Gold plating and red solder mask.
400 - MHz Arm Processor (500 Mips !).
256 - megs of Nand Flash. Create and store custom applications.
64 - megs of SD-Ram.
Dual Low Noise Switching Power Supplies, accepts 8 - 60 vdc input. Can be powered directly from 12, 24, or 48 volt battery banks.
Battery backed-up, real time clock.
One onboard temperature sensor - 25c + 100c.
Three 24 bit isolated voltmeters (+/- 100 VDC). Each voltmeter has its own 24 bit Delta Sigma ADC.
Each voltmeter can be put into low voltage shunt mode (+/- 2 VDC).
Two Power Relays for devices using up to 240v - 5 amps AC/DC current.
One programmable push button.
Four general purpose I/O pins.
Five alarm input pins.
One console serial port for full terminal access.
Two USB 2.0 ports for cameras, wireless clients, extra Ethernet, etc.
Runs real Linux! 2.6.33 kernel.
Send SMS messages, Email alerts, SNMP traps, Remote Syslog Messages.
Ping watchdog, power cycle equipment after a set amount of ping timeouts.
Command line utilities: ping, ftp, email, relays, etc.
Flash new firmware over the internet.
Duel Watchdog Reset circuits, processor integrated, and extra hardware.
Control RMS-100 via web page, telnet, ssh, or snmp.
Full SNMP v1, v2, v3 support (default v3).
Supports external USB relays and voltmeters.
Hardware is user accessible from files on the board.
Make your own utilities and scripts to upload. (Bash, PHP, Python, Lua)
Pluggable connectors for ease of use.
|
|
 |
 |
 |
 |
|
 |


|